ID #3584

Atéo Concepts: Ateo Keyboard Interface

Connection: Other



Part 1 - 111K
Part 2 - 99K

Keyboard interface designed for use with the A1200 and the Ateo Tower to allow the use of PC keyboards.

- two chips
- a power connector ( like the one for the floppy drives )
- the keyboard connector, which is directly accessable at the back of the tower
- 4 wires going to a connector, which is plugged onto the MPU keyboard chip
- a jumper, which maps the CTRL-WINDOWS-WINDOWS to the reset
- a connector so that one can connect the RESET switch of the tower

The 4 wires are not very well protected and very fragile, so take great care when installing the interface.

Download the Manual (French)

Contributions to this page by:
Olivier Croquette

Letzte Änderung des Artikels: 2009-01-26 09:35
Revision: 1.0

Drucken {writeSend2FriendMsgTag}
Rate this FAQ

Average rating: 0 (0 Votes)

completely useless 1 2 3 4 5 most valuable

Average rating: 0 (0 Votes)

You cannot comment on this entry