ID #3408

Village Tronic: Pablo II

Connection: PCI (Custom)



Hi Res Version, Front - 270K
Hi Res Version, Back - 271K

Encodes the signal from your Picasso IV to a standard video signal so it can be output to a VCR. This card requires the Picasso IV graphics card and uses its local PCI bus. Please note, the Pablo II does not use the original NTSC or PAL video signal from the Amiga's native chipset but the signal directly generated by the Picasso IV.

The following video signals are supported.
o NTSC-EIA (the NTSC variant used in Japan)
o PAL B, G and I
o PAL M (a 60 Hz variant of PAL)

S-VHS Output Connector

Contributions to this page by:
Rob Goodison, Takahasi Kasiko, Ulrich Sprenger

Letzte Änderung des Artikels: 2009-01-25 20:20
Revision: 1.0

Drucken {writeSend2FriendMsgTag}
Rate this FAQ

Average rating: 0 (0 Votes)

completely useless 1 2 3 4 5 most valuable

Average rating: 0 (0 Votes)

You cannot comment on this entry