- Home
- Show all categories
- Models & Clones
- A1000 Accelerators
- A1200 Accelerators
- A2000 Accelerators
- A3000 Accelerators
- A4000 Accelerators
- A500 Accelerators
- A600 Accelerators
- Bridgeboards & Emulator Cards
- CD32 Accelerators
- CDTV Accelerators
- Custom Chips
- Digtizers & Framegrabbers
- Flickerfixer & Scandoubler
- Floppy Controller
- Genlocks
- Graphics (non RTG) & Video Cards
- Graphics Cards (RTG)
- I/O Karten
- IDE Controller
- ISDN & Modem
- Keyboards & Adapters
- Kickstart Switchers
- MIDI Devices
- Misc ZORRO Cards
- Misc. Hardware
- Monitors
- Network Cards
- Processors
- RAM Expansions
- Scanner
- SCSI Controller
- Sound Cards
- Soundsampler
- Tape Drives & Backup
- Time Base Correctors
- Tower Kits
- Zorro Extenders & Busboards
- Mystery Corner
- Browse by Connection
- Sitemap
SCSI Controller
Amitrix: SCSI-TV / SCSI-TV/570
Connection: Andere |
SCSI-TV installs easily in the expansion port accessible at the rear of the CDTV or A570, without opening the case. A 2.5 inch Quantum GO drive may be mounted on the SCSI-TV circuit board and an external connector can connect to hard drives, scanners, and tape backups, to a total of seven devices.
SCSI-TV supports the Amiga AUTOCONFIG(TM) standard, providing autobooting capability with Rigid Disk Block support, as well as the SCSI-direct protocol allowing many backup programs to use SCSI tape drives. True DMA allows for fast data transfer rates and low CPU overhead
Dimensions: Width 3.1 inches, Length 6.25 inches
SCSI-TV for the CDTV protrudes 1.75 inches out the back of the CDTV,
and includes a black endcap for the unit. SCSI-TV/570 for the A570
extends approximately 5 inches out the back of the A570, and includes a
white end cap for the unit to match the A570.
Power consumption:
SCSI-TV alone draws about 12 milliamps, a GO-drive will draw a maximum
of about one Amp on startup and about half that during operation.
Typical for Quantum 2.5" GO-drive:
Idle 1.65 Watts (0.33 Amps)
Running 2.20 Watts (0.44 Amps)
Spinup 5.50 Watts (0.90 Amps)
Connectors:
50-pin internal and 25-pin external connectors.
The internal connector is a 2mm connector after passing through a 0.1 inch IDC header.
The external connector is a standard female DB-25.
An FAQ for this board can be found on Amitrix's website.
Contributions to this page by:
Erik Inge Bols?
Letzte Änderung des Artikels: 2009-01-27 11:26
Revision: 1.0
You cannot comment on this entry