- Home
- Show all categories
- Models & Clones
- A1000 Accelerators
- A1200 Accelerators
- A2000 Accelerators
- A3000 Accelerators
- A4000 Accelerators
- A500 Accelerators
- A600 Accelerators
- Bridgeboards & Emulator Cards
- CD32 Accelerators
- CDTV Accelerators
- Custom Chips
- Digtizers & Framegrabbers
- Flickerfixer & Scandoubler
- Floppy Controller
- Genlocks
- Graphics (non RTG) & Video Cards
- Graphics Cards (RTG)
- I/O Karten
- IDE Controller
- ISDN & Modem
- Keyboards & Adapters
- Kickstart Switchers
- MIDI Devices
- Misc ZORRO Cards
- Misc. Hardware
- Monitors
- Network Cards
- Processors
- RAM Expansions
- Scanner
- SCSI Controller
- Sound Cards
- Soundsampler
- Tape Drives & Backup
- Time Base Correctors
- Tower Kits
- Zorro Extenders & Busboards
- Mystery Corner
- Browse by Connection
- Sitemap
Network Cards
Village Tronic: Ariadne
Connection: Zorro II |
Rev 1.2 version
Hi Res Version - 693K
Type | Ethernet |
10Base2 (BNC & Coax, ThinNet): | Yes |
10Base5 (AUI & Coax, ThickNet): | No |
10BaseT (RJ45 & UTP): | Yes |
100BaseTX (RJ45 & UTP): | No |
SANA-II Driver: | Yes (ariadne.device and liana.device) |
MNI Driver: | Yes (z2-am7990.mni) |
Other Driver: | No |
The Ariadne is a full length Zorro II card with 32 Kbytes of buffer RAM on board and also an option for a boot EPROM. The Ariadne also includes two parallel ports, which are exactly the same as those found on the A4000. A SANA-II driver called Liana is also supplied for use with the parallel ports, as well as a parnet driver. There may also be a driver supplied for use with Amix, but this has not been confirmed.
Board Layout
_____________________________________________________________
| Parallel Port 2 1234 1 _____ |___
| ############ OOOO ::: | | |
| JP1 .. 1 LEDs LED |EPROM| |#
| Boot Connector| | |# DB25
| | | |# Parallel
| |_____| |# Port 1
| |#
| |
| #| RJ45
| #| 10BASE-T
| |_
| |_| BNC
|_____________________________________________________________| 10BASE-2
||||||||||||||||||||||||||| | Jumpers
JP1: Enable Boot ROM?
Off: Set to disable autobooting (default).
On: Set to enable autobooting from an on-board EPROM.
Connectors
LED connector
Pin | Function |
---|---|
1 | LED 1, Twisted pair MAU link status |
2 | LED 2, Transmit Status |
3 | +5V |
4 | LED 3, Collision |
5 | +5V |
6 | LED 4, Receive Status |
Contributions to this page by:
Greg Scott (National Amiga), RiWa & Friends
Letzte Änderung des Artikels: 2009-01-26 21:37
Revision: 1.0
You cannot comment on this entry