- Home
- Show all categories
- Models & Clones
- A1000 Accelerators
- A1200 Accelerators
- A2000 Accelerators
- A3000 Accelerators
- A4000 Accelerators
- A500 Accelerators
- A600 Accelerators
- Bridgeboards & Emulator Cards
- CD32 Accelerators
- CDTV Accelerators
- Custom Chips
- Digtizers & Framegrabbers
- Flickerfixer & Scandoubler
- Floppy Controller
- Genlocks
- Graphics (non RTG) & Video Cards
- Graphics Cards (RTG)
- I/O Karten
- IDE Controller
- ISDN & Modem
- Keyboards & Adapters
- Kickstart Switchers
- MIDI Devices
- Misc ZORRO Cards
- Misc. Hardware
- Monitors
- Network Cards
- Processors
- RAM Expansions
- Scanner
- SCSI Controller
- Sound Cards
- Soundsampler
- Tape Drives & Backup
- Time Base Correctors
- Tower Kits
- Zorro Extenders & Busboards
- Mystery Corner
- Browse by Connection
- Sitemap
Zorro Extenders & Busboards
Eyetech: Single Slot Zorro Adaptor
Connection: Trapdoor Slot (A1200) |
Single Slot Zorro Adaptor
Hi Res Version, Single Slot Zorro Adaptor - 388K
Zorro II: | 1 | |
Zorro III: | None | |
ISA: | None | |
PCI: | None | |
Video Slots: | None | |
Other: | None |
The card connects to the A1200 trapdoor connector and provides it with a single Zorro II slot. You cannot fit this in a standard A1200, it must be used in a towered A1200. The board includes a pass through for attaching your accelerator. Two slightly different versions of this board were available, one with an onboard keyboard interface and one without. The board measures about 3" x 6". Due to the angle of the Zorro II slot it may not be physically possible to install it in many tower systems however the power tower is known to be ok, although if the Zorro II card has a backplate with connectors on it, you'll not be able to access these from outside the tower without some custom solution
Letzte Änderung des Artikels: 2009-01-29 16:04
Revision: 1.0
You cannot comment on this entry