- Home
- Show all categories
- Models & Clones
- A1000 Accelerators
- A1200 Accelerators
- A2000 Accelerators
- A3000 Accelerators
- A4000 Accelerators
- A500 Accelerators
- A600 Accelerators
- Bridgeboards & Emulator Cards
- CD32 Accelerators
- CDTV Accelerators
- Custom Chips
- Digtizers & Framegrabbers
- Flickerfixer & Scandoubler
- Floppy Controller
- Genlocks
- Graphics (non RTG) & Video Cards
- Graphics Cards (RTG)
- I/O Karten
- IDE Controller
- ISDN & Modem
- Keyboards & Adapters
- Kickstart Switchers
- MIDI Devices
- Misc ZORRO Cards
- Misc. Hardware
- Monitors
- Network Cards
- Processors
- RAM Expansions
- Scanner
- SCSI Controller
- Sound Cards
- Soundsampler
- Tape Drives & Backup
- Time Base Correctors
- Tower Kits
- Zorro Extenders & Busboards
- Mystery Corner
- Browse by Connection
- Sitemap
Sound Cards
IVS (Interactive Video Systems): Perisound
Digital Audio Design: Wavetools |
Connection: Zorro II |
Drivers | |
---|---|
AHI: | Yes |
Other: | Yes (dad_audio.device) |
The Wavetools is a half length Zorro II card, capable of sampling and audio playback in 16bit. Early versions of this card were called Perisound and were manufactured by ASD. The rear faceplate is connected to the card via a small cable which connects onto the rear edge of the card. The card was supplied with some basic sampling and plauying software as well as a driver for the card called dad_audio.device. This device driver is still required, even if the card is in use under AHI. There are a block of jumpers labelled JP3, however the manual does not mention what these are for. By default pins 1-2 are shorted.
Connections
1 x RCA OUT
1 x RCA IN
2 x RCA AUDIO (Left + Right)
1 x 50pin IDC Connector (probably for future expansions)
Contributions to this page by:
Christian Nilsson
Letzte Änderung des Artikels: 2009-01-29 11:30
Revision: 1.0
You cannot comment on this entry