- Home
- Show all categories
- Models & Clones
- A1000 Accelerators
- A1200 Accelerators
- A2000 Accelerators
- A3000 Accelerators
- A4000 Accelerators
- A500 Accelerators
- A600 Accelerators
- Bridgeboards & Emulator Cards
- CD32 Accelerators
- CDTV Accelerators
- Custom Chips
- Digtizers & Framegrabbers
- Flickerfixer & Scandoubler
- Floppy Controller
- Genlocks
- Graphics (non RTG) & Video Cards
- Graphics Cards (RTG)
- I/O Karten
- IDE Controller
- ISDN & Modem
- Keyboards & Adapters
- Kickstart Switchers
- MIDI Devices
- Misc ZORRO Cards
- Misc. Hardware
- Monitors
- Network Cards
- Processors
- RAM Expansions
- Scanner
- SCSI Controller
- Sound Cards
- Soundsampler
- Tape Drives & Backup
- Time Base Correctors
- Tower Kits
- Zorro Extenders & Busboards
- Mystery Corner
- Browse by Connection
- Sitemap
A1200 Accelerators
ACT Elektronik Vertriebs GmbH: Apollo 1240
Wizard Developments: Magnum 1240 |
Connection: Trapdoor Slot (A1200) |
Apollo 1240, 040@28Mhz
Apollo 1240, 040@28Mhz, rear (heatsink and fan missing)
Hi Res Version of Image 1 - 281K
Hi Res Version of Image 1 - 337K
Hi Res Version, Apollo 1240, 040@28Mhz - 1591K
Hi Res Version, Apollo 1240, 040@28Mhz, rear (heatsink and fan missing) - 1839K
Hi Res Version of Front - 68K
Hi Res Version of Back - 56K
Processor: | 040@25Mhz, 040@33Mhz or 040@40Mhz |
FPU: | Internal |
MMU: | Internal |
Max Ram: | 32MB (64MB with additional SIMM socket) |
Ram Type: | 1 x 72pin SIMM socket. (An additional SIMM socket can be fitted), (EDO RAM works but is not taken advantage of) |
An accelerator which plugs into the trapdoor slot of the A1200. An optional SCSI-II controller was available for this card. It is fully PCMCIA compatible and an additional SIMM socket could be fitted by the dealer, or end user if they were competent enough.
Jumpers
Jumper | OFF | ON |
---|---|---|
RAM | Turn off RAM | Turn on RAM |
SCSI | Disable SCSI Autoboot | Enable SCSI Autoboot |
Processor | 040 Installed | 060 Installed |
SCSI Jumper
The SCSI interface's autoboot option should be turned off if there are no bootable devices or any devices at all attached to the SCSI bus. This prevents a 30 second delay while the system attempts to detect bootable SCSI devices. It is possible to upgrade this card to an 060 with an appropriate voltage regulator.
CLK Jumper
Processor | Position |
---|---|
040 @ any Mhz | Set to 040 |
060@50Mhz | Set to 060 |
060@66Mhz | Set to 040 |
Contributions to this page by:
Ian Stedman, RiWa & Friends, Stephan Neise
Letzte Änderung des Artikels: 2009-01-24 20:15
Revision: 1.0
You cannot comment on this entry