ID #3088

Phase 5: PPC Developer Board

Connection: CPU Sockel

Front of PPC Developer Board
Front of PPC Developer Board

Back of PPC Developer Board
Back of PPC Developer Board

PPC Developer board attached to CS Mk-II
PPC Developer board attached to CS Mk-II

Hi Res Version, Front of PPC Developer Board - 286K
Hi Res Version, Back of PPC Developer Board - 337K
Hi Res Version, PPC Developer board attached to CS Mk-II - 351K
Another image of PPC Developer board attached to CS Mk-II - 482K
Image of PPC Developer board, manual and box - 636K
Closeup of PPC CPU - 706K

Processor: 603@150Mhz (or possibly 166Mhz)
FPU: Internal
MMU: Internal
Max Ram: Does not support the addition of RAM. Uses the existing RAM on the Cyberstorm Mk-II

This accelerator is an early prototype of what eventually became the Cyberstorm PPC. Unlike the Cyberstorm PPC which was eventually released, this version was designed to be plugged into the 060 socket of the Cyberstorm Mk-II. The 060 which was removed from the Cyberstorm Mk-II is then installed onto the PowerPC board, along with an additional PowerPC processor. This device is reported to actually work with WarpOS providing you install it with the "Developer Board" option. It may also work with PowerUp, but this has not been confirmed.

Contributions to this page by:
Iggy Drougge, Jan Pedersen, Sebastian Fahrner

Letzte Änderung des Artikels: 2009-01-25 12:50
Revision: 1.0

Drucken {writeSend2FriendMsgTag}
Rate this FAQ

Average rating: 0 (0 Votes)

completely useless 1 2 3 4 5 most valuable

Average rating: 0 (0 Votes)

You cannot comment on this entry