- Home
- Show all categories
- Models & Clones
- A1000 Accelerators
- A1200 Accelerators
- A2000 Accelerators
- A3000 Accelerators
- A4000 Accelerators
- A500 Accelerators
- A600 Accelerators
- Bridgeboards & Emulator Cards
- CD32 Accelerators
- CDTV Accelerators
- Custom Chips
- Digtizers & Framegrabbers
- Flickerfixer & Scandoubler
- Floppy Controller
- Genlocks
- Graphics (non RTG) & Video Cards
- Graphics Cards (RTG)
- I/O Karten
- IDE Controller
- ISDN & Modem
- Keyboards & Adapters
- Kickstart Switchers
- MIDI Devices
- Misc ZORRO Cards
- Misc. Hardware
- Monitors
- Network Cards
- Processors
- RAM Expansions
- Scanner
- SCSI Controller
- Sound Cards
- Soundsampler
- Tape Drives & Backup
- Time Base Correctors
- Tower Kits
- Zorro Extenders & Busboards
- Mystery Corner
- Browse by Connection
- Sitemap
Misc. Hardware
ID #3776
Hama: A-Cut
Connection: Mouse/Joystick Port, Parallel Port |
A-Cut
The A-Cut is a video editing suite designed for the Amiga. It controls one VCR for playback via Sont LANC or Panasonic's editing connector while steering the recording video via infra-red. The A-cut can be taught the IR commands of for new equipment. Material for copying can be inspected and chosen via the use of the jog-shuffle wheel. The A-Cut software is AREXX compatible and can be controlled via Scala MM400. The package was supplied with a parallel cable, joystick cable, infra-red module, SONY LANC cable, Panasonic Editing cable, manual and software.
Contributions to this page by: Iggy Drougge |
Letzte Änderung des Artikels: 2009-01-26 18:45
Revision: 1.0
Average rating: 0 (0 Votes)
You cannot comment on this entry