- Home
- Show all categories
- Models & Clones
- A1000 Accelerators
- A1200 Accelerators
- A2000 Accelerators
- A3000 Accelerators
- A4000 Accelerators
- A500 Accelerators
- A600 Accelerators
- Bridgeboards & Emulator Cards
- CD32 Accelerators
- CDTV Accelerators
- Custom Chips
- Digtizers & Framegrabbers
- Flickerfixer & Scandoubler
- Floppy Controller
- Genlocks
- Graphics (non RTG) & Video Cards
- Graphics Cards (RTG)
- I/O Karten
- IDE Controller
- ISDN & Modem
- Keyboards & Adapters
- Kickstart Switchers
- MIDI Devices
- Misc ZORRO Cards
- Misc. Hardware
- Monitors
- Network Cards
- Processors
- RAM Expansions
- Scanner
- SCSI Controller
- Sound Cards
- Soundsampler
- Tape Drives & Backup
- Time Base Correctors
- Tower Kits
- Zorro Extenders & Busboards
- Mystery Corner
- Browse by Connection
- Sitemap
Graphics (non RTG) & Video Cards
BCD Associates: BCD-2000A
Connection: ISA, Zorro II |
BCD-2000A
BCD-2000A with software
Hi Res Version, BCD-2000A - 659K
Hi Res Version, BCD-2000A with software - 1088K
Image of BCD-2000A showing backplate - 104K
Image of BCD-2000A showing backplate and software - 89K
The BCD-2000A is a full length Zorro II/III and ISA card. It only uses the ISA and Zorro slots for power, no data lines are used so it is enough to simply plug it into one slot type or the other. The card connects to the internal serial pin header in the A2000 via a ribbon cable. Because the connector for the Amiga side is keyed, it probably won't fit in A2000's which are revision 4.4 and older. Revision 6.2 motherboards have no problem. The manual states that the card can also be used in A3000 and A4000 machines using a special external serial adaptor, however this was not supplied with the board. The unit was also supplied with a floppy disk labelled "BCD Amiga FreeDisk" and a cable for connecting VTRs/VCRs.According to an advert in Video Toaster User, the BCD-2000A is a "single frame controller" with additional control features such as SMPTE Time Code generator and reader, EBU generator, RS422/232 serial and parallel controller.
Jumpers
Jumper | On | Off |
---|---|---|
Display | Sets the baud rate to 9,600 | Sets the buad rate to 19,200 |
Term | Video signal is terminated | Video signal is not terminated |
EBU | SMPTE/NTSC | EBU/PAL |
Contributions to this page by:
Francisco Rabay Jr, Robin Pillow
Letzte Änderung des Artikels: 2009-01-25 19:34
Revision: 1.0
You cannot comment on this entry