- Home
- Show all categories
- Models & Clones
- A1000 Accelerators
- A1200 Accelerators
- A2000 Accelerators
- A3000 Accelerators
- A4000 Accelerators
- A500 Accelerators
- A600 Accelerators
- Bridgeboards & Emulator Cards
- CD32 Accelerators
- CDTV Accelerators
- Custom Chips
- Digtizers & Framegrabbers
- Flickerfixer & Scandoubler
- Floppy Controller
- Genlocks
- Graphics (non RTG) & Video Cards
- Graphics Cards (RTG)
- I/O Karten
- IDE Controller
- ISDN & Modem
- Keyboards & Adapters
- Kickstart Switchers
- MIDI Devices
- Misc ZORRO Cards
- Misc. Hardware
- Monitors
- Network Cards
- Processors
- RAM Expansions
- Scanner
- SCSI Controller
- Sound Cards
- Soundsampler
- Tape Drives & Backup
- Time Base Correctors
- Tower Kits
- Zorro Extenders & Busboards
- Mystery Corner
- Browse by Connection
- Sitemap
RAM Expansions
Micronik: RCA120
Connection: Trapdoor Slot (A1200) |
Hi Res Version of Image 1 - 188K
Hi Res Version of Image 2 - 240K
Max Ram: | 8MB |
Ram Type: | 1 x 72pin SIMM slot |
FPU: | Optional 68881 or 68882 at up to 50Mhz |
RTC: | Yes |
Connection: | A1200 Trapdoor slot |
A RAM card for the A1200 which plugs into the trapdoor slot of the A1200. This card is not PCMCIA friendly if it has more than 4MB of RAM installed. If you install 8MB on the card and require the use of the PCMCIA slot, you must move JP2 to the ON position to disable the upper 4MB of RAM. Rev B versions of the card support a PGA FPU whilst Rev C's require a PLCC FPU.
SIMM Size | JP1 (1-2) | JP1 (3-4) |
---|---|---|
1MB | ON | OFF |
2MB | OFF | ON |
4MB | ON | ON |
8MB | OFF | OFF |
SIMM STYLE | JP1 (5-6) | CLOCK SPEED JP3 |
---|---|---|
Single Sided | ON | Use A1200 Clock (1-2) |
Double Sided | OFF | Use RCA Oscillator (2-3) |
Note: When running clocked from the board (14.3MHz) the JP3 jumper bock should be on the left (1-2) postion. When using a faster FPU and Oscillator, JP3 jumper block should be moved to the right (2-3) position.
Contributions to this page by:
Amiga Deals, Kokkie, Mike
Letzte Änderung des Artikels: 2009-01-27 10:23
Revision: 1.0
You cannot comment on this entry