- Home
- Show all categories
- Models & Clones
- A1000 Accelerators
- A1200 Accelerators
- A2000 Accelerators
- A3000 Accelerators
- A4000 Accelerators
- A500 Accelerators
- A600 Accelerators
- Bridgeboards & Emulator Cards
- CD32 Accelerators
- CDTV Accelerators
- Custom Chips
- Digtizers & Framegrabbers
- Flickerfixer & Scandoubler
- Floppy Controller
- Genlocks
- Graphics (non RTG) & Video Cards
- Graphics Cards (RTG)
- I/O Karten
- IDE Controller
- ISDN & Modem
- Keyboards & Adapters
- Kickstart Switchers
- MIDI Devices
- Misc ZORRO Cards
- Misc. Hardware
- Monitors
- Network Cards
- Processors
- RAM Expansions
- Scanner
- SCSI Controller
- Sound Cards
- Soundsampler
- Tape Drives & Backup
- Time Base Correctors
- Tower Kits
- Zorro Extenders & Busboards
- Mystery Corner
- Browse by Connection
- Sitemap
A3000 Accelerators
ID #3054
Commodore: Gemini Prototype
Connection: Zorro III |
Not strictly an accelerator but close enough! :) The Gemini was an attempt to build a multi-processor card designed for use on the Zorro III bus which contained two mini A3000s with 030's and 68882s as well as memory which would run a custom copy of exec. The Gemini could access all Zorro III memory and Chip RAM and each CPU could access the memory of the others. The board shown contains no CPU, FPU or RAMSEY. The board requires a Rev 11 buster since it uses "client" mode which allows it to be used as a board controller.
Contributions to this page by:
Dave Haynie
Letzte Änderung des Artikels: 2009-01-25 12:11
Revision: 1.0
Average rating: 0 (0 Votes)
You cannot comment on this entry