- Home
- Show all categories
- Models & Clones
- A1000 Accelerators
- A1200 Accelerators
- A2000 Accelerators
- A3000 Accelerators
- A4000 Accelerators
- A500 Accelerators
- A600 Accelerators
- Bridgeboards & Emulator Cards
- CD32 Accelerators
- CDTV Accelerators
- Custom Chips
- Digtizers & Framegrabbers
- Flickerfixer & Scandoubler
- Floppy Controller
- Genlocks
- Graphics (non RTG) & Video Cards
- Graphics Cards (RTG)
- I/O Karten
- IDE Controller
- ISDN & Modem
- Keyboards & Adapters
- Kickstart Switchers
- MIDI Devices
- Misc ZORRO Cards
- Misc. Hardware
- Monitors
- Network Cards
- Processors
- RAM Expansions
- Scanner
- SCSI Controller
- Sound Cards
- Soundsampler
- Tape Drives & Backup
- Time Base Correctors
- Tower Kits
- Zorro Extenders & Busboards
- Mystery Corner
- Browse by Connection
- Sitemap
IDE Controller
Vortex: Athlet
Connection: Zorro II |
Larger image of Athlet - 75K
The Athlet is a full length Zorro II card which provides the Amiga with a 3.5" IDE interface. The original configurations came with a 43/90/130 or 180MB Fujtisu hard disk. The hard disk can be mounted and powered directly from the card. The card also has 4 x 30pin SIMM slots (o waitstates) for up to an additional 4MB of RAM. SIMMs must be added in pairs and only 1MB SIMMs are supported. The memory is configured by jumpers on the card. Another jumper tells the card if it is being used under Kickstart 1.2 or 1.3 and autobooting is possible under both versions. At least early versions of this board are reported to have problems if RAM is used on the card, as well as additional 32bit RAM being used on an accelerator.
Contributions to this page by:
Jan Dwornizky, Rainer Schreurs
Letzte Änderung des Artikels: 2009-01-26 09:19
Revision: 1.0
You cannot comment on this entry