- Home
- Show all categories
- Models & Clones
- A1000 Accelerators
- A1200 Accelerators
- A2000 Accelerators
- A3000 Accelerators
- A4000 Accelerators
- A500 Accelerators
- A600 Accelerators
- Bridgeboards & Emulator Cards
- CD32 Accelerators
- CDTV Accelerators
- Custom Chips
- Digtizers & Framegrabbers
- Flickerfixer & Scandoubler
- Floppy Controller
- Genlocks
- Graphics (non RTG) & Video Cards
- Graphics Cards (RTG)
- I/O Karten
- IDE Controller
- ISDN & Modem
- Keyboards & Adapters
- Kickstart Switchers
- MIDI Devices
- Misc ZORRO Cards
- Misc. Hardware
- Monitors
- Network Cards
- Processors
- RAM Expansions
- Scanner
- SCSI Controller
- Sound Cards
- Soundsampler
- Tape Drives & Backup
- Time Base Correctors
- Tower Kits
- Zorro Extenders & Busboards
- Mystery Corner
- Browse by Connection
- Sitemap
Network Cards
ID #3923
CEI: A4066 Ethernet/PLUS
Ameristar: A4066 Ethernet/PLUS |
Connection: Zorro II |
Type | Ethernet |
10Base2 (BNC & Coax, ThinNet): | Yes |
10Base5 (AUI & Coax, ThickNet): | Yes |
10BaseT (RJ45 & UTP): | Yes |
100BaseTX (RJ45 & UTP): | No |
SANA-II Driver: | Yes |
MNI Driver: | Yes (z2-smc91c90.mni) |
Other Driver: | No |
Full length Zorro II ethernet card. This card was made both my Ameristar and CEI so therefore two different card ID's and manufacturer numbers may exist. The card has two LED's onboard, when in 10BaseT mode, red means transmit and green means receive. When it 10Base2/5 mode, the red LED indicates both receive and transmit and green is not used.
Jumpers
The card is shipped for use with 10Base 2 by default
10BaseT: | Shunt JP3 plug OUT |
10Base2: | Shunt JP3 plug IN and Shunt JP1 plug into THIN position |
10Base5: | Shunt JP3 plug IN and Shunt JP1 plug into AUI position |
JP2 is for factory use only and should not be altered by the user.
Letzte Änderung des Artikels: 2009-01-26 21:22
Revision: 1.0
Average rating: 0 (0 Votes)
You cannot comment on this entry