- Home
- Show all categories
- Models & Clones
- A1000 Accelerators
- A1200 Accelerators
- A2000 Accelerators
- A3000 Accelerators
- A4000 Accelerators
- A500 Accelerators
- A600 Accelerators
- Bridgeboards & Emulator Cards
- CD32 Accelerators
- CDTV Accelerators
- Custom Chips
- Digtizers & Framegrabbers
- Flickerfixer & Scandoubler
- Floppy Controller
- Genlocks
- Graphics (non RTG) & Video Cards
- Graphics Cards (RTG)
- I/O Karten
- IDE Controller
- ISDN & Modem
- Keyboards & Adapters
- Kickstart Switchers
- MIDI Devices
- Misc ZORRO Cards
- Misc. Hardware
- Monitors
- Network Cards
- Processors
- RAM Expansions
- Scanner
- SCSI Controller
- Sound Cards
- Soundsampler
- Tape Drives & Backup
- Time Base Correctors
- Tower Kits
- Zorro Extenders & Busboards
- Mystery Corner
- Browse by Connection
- Sitemap
Bridgeboards & Emulator Cards
Vortex: Golden Gate 486SLC / 486SLC II
Connection: ISA, Zorro II |
Image of A2000 68000 CPU adaptor - 88K
Emulates: | PC |
Processor: | Intel 486slc@25Mhz, Intel 486slc@50Mhz (SCL II), optional 387/487 FPU |
RAM: | 2MB (expandable to 16MB via 30pin SIMMs) |
Graphics Emulation: | CGA EGA VGA Mono Hercules Olivetti Toshiba Note: at least 21 other modes supported (can use real ISA graphics cards) |
Sound Emulation: | Real PC Speaker (can use real ISA sound cards) |
A full length card which plugs into both a Zorro II slot and an ISA slot. It lets your Amiga run PC software as fast as a real 486. The card also contains an onboard external disk drive connector, IDE controller and an option connector for use with the Monitor Master. This card can use any real ISA card plugged into the ISA slots from the PC side. Apparently 2 or 4MB of memory can actually be allocated for use by the Amiga and some Amiga memory can be allocated for use by the card, but this must be 24bit memory only. The card was supplied with an optional 2.88MB floppy drive controller, however the Amiga's native floppy drives can be used as if they were PC drives. Note: If the card is used in an A2000, then you must use the 68000 CPU adaptor or the card will not work. The adaptor consists of a 68000 socket with a small capacitor (about 10nF) soldered between pins 12 and 14. The 68000 processor should be removed from the motherboard, placed into the adaptor and then reseated.
Memory Configuration
Slot 1&2 | Slot 3&4 | Total |
---|---|---|
- | - | 512K on board |
256K | - | 1MB |
256K | 256K | 1.5MB |
1MB | - | 2.5MB |
256KB | 1MB | 3MB |
1MB | 1MB | 4.5MB |
- | 4MB | 8MB |
256KB | 4MB | 9MB |
1MB | 4MB | 10MB |
4MB | 4MB | 16MB |
Contributions to this page by:
Jan Dwornizky, Jason Watson, Orjan Lindgren, Robert Harrison, Thomas Vetter
Letzte Änderung des Artikels: 2009-01-25 14:28
Revision: 1.0
You cannot comment on this entry