- Home
- Show all categories
- Models & Clones
- A1000 Accelerators
- A1200 Accelerators
- A2000 Accelerators
- A3000 Accelerators
- A4000 Accelerators
- A500 Accelerators
- A600 Accelerators
- Bridgeboards & Emulator Cards
- CD32 Accelerators
- CDTV Accelerators
- Custom Chips
- Digtizers & Framegrabbers
- Flickerfixer & Scandoubler
- Floppy Controller
- Genlocks
- Graphics (non RTG) & Video Cards
- Graphics Cards (RTG)
- I/O Karten
- IDE Controller
- ISDN & Modem
- Keyboards & Adapters
- Kickstart Switchers
- MIDI Devices
- Misc ZORRO Cards
- Misc. Hardware
- Monitors
- Network Cards
- Processors
- RAM Expansions
- Scanner
- SCSI Controller
- Sound Cards
- Soundsampler
- Tape Drives & Backup
- Time Base Correctors
- Tower Kits
- Zorro Extenders & Busboards
- Mystery Corner
- Browse by Connection
- Sitemap
Mystery Corner
Datel: RAM-Master II
Connection: Trapdoor Slot (A500/+) |
Ram-Master II front
Ram-Master II back
Front view - 203K
rear view - 225K
Closeup of battery - 315K
Ram-Master II installed - 490K
A RAM expansion wich connects to the A500/+ trapdoor slot. The card gives the Amiga 512k of more FastRAM. The GARY chip must be pulled out and reattached on the little GARY adaptor PCB to install the card. It seemes, that the device also have a RTC.
Note: If you dont connect the gary adaptor then you have only 0,5MB Fastram added. If you connect the gary adaptor in wrong Direction (Like the picture) your amiga stil Boot but only with 0,5MB instead of 1,5MB Fastram. You can see on the adaptor socket a gap, that must be on thesame direction like the Gary-Chip on the A500. Some models has a disable switch connected on the 2 solderpoints on the left side from the Battery.
Contributions to this page by:
Paul Moore
Letzte Änderung des Artikels: 2009-01-29 16:18
Revision: 1.0
You cannot comment on this entry