ID #4325

Phase 5: CyberSCSI MK-II Modul

Connection: Other

CyberSCSI MK-II Modul
CyberSCSI MK-II Modul

CyberSCSI MK-II Modul with items
CyberSCSI MK-II Modul with items

Hi Res Version, CyberSCSI MK-II Modul - 824K
Hi Res Version, CyberSCSI MK-II Modul with items - 754K
Image of Box - 537K

The CyberSCSI Mk-II is a Fast SCSI-II controller which is attached to the Cyberstorm Mk-II accelerator. The unit comes in two sections. The first section attaches directly to the accelerator and provides 2 x 50pin headers. The second section provides an external 50pin SCSI connector and this is attached to the first section via a 50pin ribbon cable. The module supports 32bit DMA transfers at up to 10MB/sec.

Jumpers

On the external board, there is only one jumper:

  • Pins 1-2: Auto Termination
  • Pins 2-3: Termination Off
  • No Pins: Termination On

On the main SCSI-board there is SCSI-config jumper block in the centre of this board.

Jumper Function Default
0 Debug Mode Open
1 Reserved Open
2 Slow Inquiry Mode Open
3 Slow Cable Mode Open
4 Synchronous Transfers Open
0 Reserved Open
Under / Left Hard disk LED connector  
Upper / Right Termination Power Close = Enabled

Contributions to this page by:
Brandon Bertolli, Francisco Rabay Jr, Patrik Sjoblom, RiWa & Friends

Letzte Änderung des Artikels: 2009-01-29 10:59
Revision: 1.0

Drucken {writeSend2FriendMsgTag}
Rate this FAQ

Average rating: 0 (0 Votes)

completely useless 1 2 3 4 5 most valuable

Average rating: 0 (0 Votes)

You cannot comment on this entry