- Home
- Show all categories
- Models & Clones
- A1000 Accelerators
- A1200 Accelerators
- A2000 Accelerators
- A3000 Accelerators
- A4000 Accelerators
- A500 Accelerators
- A600 Accelerators
- Bridgeboards & Emulator Cards
- CD32 Accelerators
- CDTV Accelerators
- Custom Chips
- Digtizers & Framegrabbers
- Flickerfixer & Scandoubler
- Floppy Controller
- Genlocks
- Graphics (non RTG) & Video Cards
- Graphics Cards (RTG)
- I/O Karten
- IDE Controller
- ISDN & Modem
- Keyboards & Adapters
- Kickstart Switchers
- MIDI Devices
- Misc ZORRO Cards
- Misc. Hardware
- Monitors
- Network Cards
- Processors
- RAM Expansions
- Scanner
- SCSI Controller
- Sound Cards
- Soundsampler
- Tape Drives & Backup
- Time Base Correctors
- Tower Kits
- Zorro Extenders & Busboards
- Mystery Corner
- Browse by Connection
- Sitemap
Graphics (non RTG) & Video Cards
Ingenieur Helfrich: Peggy Plus
Scala:Â Peggy Plus |
Connection: Video Slot, Zorro II |
Rev 1.1 Peggy Plus
Peggy Plus backplate
Hi Res Version, Rev 1.1 Peggy Plus - 202K
Closeup, left side of card - 328K
Closeup, right side of card - 392K
Hi Res Version, backplate - 87K
The Peggy Plus is a full length Zorro II card which also uses a video slot to display MPEG video. It has composite out (with optional daughter board), RGB out and 16bit audio out with a pass-thru for Amiga sound. It can also play MP2 sound with minimal CPU usage. The Peggy Plus plays video CDs and MPEGs at 30fps even on an 030 based 4000. Supplied with MPEG video software, the Scala MD100EX extension also works well with this card. It also has a built in genlock for placing Amiga Graphics over the MPEG video.
Jumpers
JP1:
1-2: Hsync on output
2-3: Csync on output
The default is 1-2 so a standard VGA monitor can be connected. Most MPEGs however, only play at a rate of 15Khz so many monitors won't display it.
Contributions to this page by:
Frank Cieslewicz, Julian Cassin, Simon Vergauwen, Thomas Reiss
Letzte Änderung des Artikels: 2009-01-25 19:48
Revision: 1.0
You cannot comment on this entry