- Home
- Show all categories
- Models & Clones
- A1000 Accelerators
- A1200 Accelerators
- A2000 Accelerators
- A3000 Accelerators
- A4000 Accelerators
- A500 Accelerators
- A600 Accelerators
- Bridgeboards & Emulator Cards
- CD32 Accelerators
- CDTV Accelerators
- Custom Chips
- Digtizers & Framegrabbers
- Flickerfixer & Scandoubler
- Floppy Controller
- Genlocks
- Graphics (non RTG) & Video Cards
- Graphics Cards (RTG)
- I/O Karten
- IDE Controller
- ISDN & Modem
- Keyboards & Adapters
- Kickstart Switchers
- MIDI Devices
- Misc ZORRO Cards
- Misc. Hardware
- Monitors
- Network Cards
- Processors
- RAM Expansions
- Scanner
- SCSI Controller
- Sound Cards
- Soundsampler
- Tape Drives & Backup
- Time Base Correctors
- Tower Kits
- Zorro Extenders & Busboards
- Mystery Corner
- Browse by Connection
- Sitemap
Digtizers & Framegrabbers
Rombo: Vidi RGB
Connection: Mouse/Joystick Port, Video Socket (Amiga 23pin) |
Hi Res Version - 61K
VidiRGB front - 347K
VidiRGB back - 300K
VidiChrome connected - 365K
VidiRGB and Chrome connected - 539K
Sold as 2Packs : - Vidi Amiga (only the Digitizer with a Colourfilterwheel) : - Vidi Chrome (Vidi Amiga + Vidi RGB (electronic coloursplitter) The Vidi-Amiga is a video digitizer which is capable of capturing realtime video in up to 16 grey-scales, or colour stills at up to 4096 colours - Connected in the Parallel port (digitizing) & the Drive port (power supply). - Composite input RCA Connection - Because his design the A2000 Videoport is Blocked, so extention Kabel for the parallel port is needed but not if you use a Flickerfixer Card in the Video slot) - Brightness and Contrast adjustments The Vidi RGB is an electronic coloursplitter for the Vidi Amiga Digitizer or DigiView Digitizer - Composite Input & Output - Take Power via an external port - Factory Sealed Connector (Dont Connect Anything on that Port) - Brightness and Contrast Adjustments. - RGB Button on Top and RGB ColourLed. - Uses also the Joystick Port (For Controlling the RGB i think) First use : Install the software and the digitizer first , connect a Composite Source , and adjust the Brightness & Contrast. After that u can connect the RBG Splitter and Adjust the Brightness and Contrast from the RGB Splitter. (Composite Source now in the splitter, and the splitter in the Digitizer). The Vidi Chrome soft Does Not Controls the RGB Splitter so manuel pushing the RGB Button is needed than the software merge the RGB Picrures. The digitizer was build before the A1200 and A4000 whas build but Works with AGA Amigas with Vidi12 Software. The Vidi12 Soft Can Control the RGB Splitter Automatic.
Contributions to this page by:
Matthias Latocha, Tom Sparks, Yvan Van Mullem
Letzte Änderung des Artikels: 2009-01-25 17:27
Revision: 1.0
You cannot comment on this entry