- Home
- Show all categories
- Models & Clones
- A1000 Accelerators
- A1200 Accelerators
- A2000 Accelerators
- A3000 Accelerators
- A4000 Accelerators
- A500 Accelerators
- A600 Accelerators
- Bridgeboards & Emulator Cards
- CD32 Accelerators
- CDTV Accelerators
- Custom Chips
- Digtizers & Framegrabbers
- Flickerfixer & Scandoubler
- Floppy Controller
- Genlocks
- Graphics (non RTG) & Video Cards
- Graphics Cards (RTG)
- I/O Karten
- IDE Controller
- ISDN & Modem
- Keyboards & Adapters
- Kickstart Switchers
- MIDI Devices
- Misc ZORRO Cards
- Misc. Hardware
- Monitors
- Network Cards
- Processors
- RAM Expansions
- Scanner
- SCSI Controller
- Sound Cards
- Soundsampler
- Tape Drives & Backup
- Time Base Correctors
- Tower Kits
- Zorro Extenders & Busboards
- Mystery Corner
- Browse by Connection
- Sitemap
Monitors
YCP (Y/C Plus): YCP-20MA
Connection: Other |
19" RGB Colour monitor which supports PAL/NTSC modes only. It also supports Y/C and Composite inputs. Only one input should be used at a time
AMIGA OR RGB INPUT:
First, the
input select switch on the back of the monitor must be in the "UP"
position. Second, S-Video must be selected as a input via the menu
display. Depress the menu (-) down button for the on-screen display.
Note: you may want to discon- nect the DB9 cable because the menu
display is shared with the RGB input. Use the menu (+/-) buttons to
locate the source input. Use the volume up (+) or volume down (-) to
select S-Video (Y/C) in.
Y/C OR S-VIDEO INPUT:
First, the
Input Select switch on the back of the monitor must be in the "DOWN"
position. Second, the S-Video input must be selected via the on- screen
menu.
COMPOSITE VIDEO INPUT:
First, the Input Select
switch on the back of the monitor must be the "DOWN" position. Second,
the AUX/VCR input must be selected via the on- screen menu.
CABLE OR ANTENNA INPUT:
Use the on-screen menu to select antenna input. If you have cable, you
will have to select the cable "Yes/No". The monitor has been programmed
to automatically display the Y/C input (RGB overrides). To change use
the ON CHANNEL menu display for the Power On channel for a different
input. The display menu will disappear after (1) one minute of non-use.
You can also remove the menu display by selecting EXIT in the menu.
Also, the input select switch should be in the down position. Remember
the input select switch on the back: UP for Amiga/RGB input and DOWN
for Y/C or Composite Video. Also remember only (1) one cable can be
con- nected to the monitor at any given time.
TIPS AND TROUBLESHOOTING:
If the image has a cross pulse, double image or looks like there is no
sync while in the Amiga/RGB mode, remove the Y/C or composite cable. If
there is no color in the Y/C or Composite Mode, select the correct in
via the display menu S-video for Y/C or AUX/VCR for Composite Video. If
there is no Picture in the Y/C or Composite mode, position the input
select switch to the "DOWN" position or remove the Amiga/RGB cable. If
there is no Picture in the RGB mode, be sure the input select switch is
in the "UP" position.
Contributions to this page by:
Ryan Callagher
Letzte Änderung des Artikels: 2009-01-26 21:12
Revision: 1.0
You cannot comment on this entry