- Home
- Show all categories
- Models & Clones
- A1000 Accelerators
- A1200 Accelerators
- A2000 Accelerators
- A3000 Accelerators
- A4000 Accelerators
- A500 Accelerators
- A600 Accelerators
- Bridgeboards & Emulator Cards
- CD32 Accelerators
- CDTV Accelerators
- Custom Chips
- Digtizers & Framegrabbers
- Flickerfixer & Scandoubler
- Floppy Controller
- Genlocks
- Graphics (non RTG) & Video Cards
- Graphics Cards (RTG)
- I/O Karten
- IDE Controller
- ISDN & Modem
- Keyboards & Adapters
- Kickstart Switchers
- MIDI Devices
- Misc ZORRO Cards
- Misc. Hardware
- Monitors
- Network Cards
- Processors
- RAM Expansions
- Scanner
- SCSI Controller
- Sound Cards
- Soundsampler
- Tape Drives & Backup
- Time Base Correctors
- Tower Kits
- Zorro Extenders & Busboards
- Mystery Corner
- Browse by Connection
- Sitemap
A1000 Accelerators
CSA: Midget Racer Piggyback Board
Connection: CPU Socket |
Midget Racer
Midget Racer with manual
Hi Res Version, Midget Racer - 83K
Hi Res Version, Midget Racer with manual - 61K
Processor: | 020@7.2Mhz |
FPU: | 68881 or 68882 @ up to 33Mhz (PGA) |
MMU: | No |
Ram Type: | None. Does not support the addition of memory. |
A small board measuring approximately 3.5" x 2.75" which plugs into the CPU socket. Due this card using an underclocked 020 and not supporting additional fast ram, it only achieves about a 10% speed increase of the standard 68000. The FPU can be clocked synchronously in which case it's about 7.2Mhz or an oscillator can be installed to support an FPU at up to 33Mhz. The card apparently does not work without an FPU installed.
Jumpers
For synchronous FPU clock (~7Mhz) short pins E2 and E3
For asynchronous FPU clock (uses oscillator) short pins E1 and E2
Contributions to this page by: Mech |
Letzte Änderung des Artikels: 2009-01-24 19:32
Revision: 1.0
You cannot comment on this entry