- Home
- Show all categories
- Models & Clones
- A1000 Accelerators
- A1200 Accelerators
- A2000 Accelerators
- A3000 Accelerators
- A4000 Accelerators
- A500 Accelerators
- A600 Accelerators
- Bridgeboards & Emulator Cards
- CD32 Accelerators
- CDTV Accelerators
- Custom Chips
- Digtizers & Framegrabbers
- Flickerfixer & Scandoubler
- Floppy Controller
- Genlocks
- Graphics (non RTG) & Video Cards
- Graphics Cards (RTG)
- I/O Karten
- IDE Controller
- ISDN & Modem
- Keyboards & Adapters
- Kickstart Switchers
- MIDI Devices
- Misc ZORRO Cards
- Misc. Hardware
- Monitors
- Network Cards
- Processors
- RAM Expansions
- Scanner
- SCSI Controller
- Sound Cards
- Soundsampler
- Tape Drives & Backup
- Time Base Correctors
- Tower Kits
- Zorro Extenders & Busboards
- Mystery Corner
- Browse by Connection
- Sitemap
SCSI Controller
GVP (Great Valley Products): 2000 HC+8
Connection: Zorro II |
HC+8 with manual, disk and RAM
Rev 2 HC+8
Rev 2 HC+8 with hard drive
Rev 5 HC+8
Hi Res Version, HC+8 with manual, disk and RAM - 1500K
Image Rev.1 Board - 239K
Hi Res Version, Rev 2 HC+8 - 1286K
Hi Res Version, Rev 2 HC+8 with hard drive - 575K
Hi Res Version, Rev 5 HC+8 - 142K
A full length Zorro II scsi card which contains 8 x 30pin SIMM slots for up tp 8MB of additional RAM. The card also gas enough space to mount a hard drive directly onto the card. The card was often supplied with a SCSI hard drive, usually a 52MB Quantum.
RAM Configuration
The SIMMs are inserted from CN10 onwards and must be done in increments of 2MB, therefore 0, 2, 4, 6, 8MB are the only possible RAM configurations.
RAM Jumpers
Memory | SIMM Locations | J5 | J6 | J7 | J8 | J9 |
---|---|---|---|---|---|---|
0MB | NONE | OFF | OFF | ON | OFF | ON |
2MB | CN10-CN11 | OFF | ON | OFF | OFF | ON |
4MB | CN10-CN13 | ON | OFF | OFF | OFF | ON |
6MB | CN10-CN15 | OFF | OFF | ON | ON | OFF |
8MB | CN10-CN17 | OFF | ON | OFF | ON | OFF |
Connectors
Connector | Function |
---|---|
J4 | Hard Drive Autobooting |
J10-J12 | SCSI ID Jumpers |
CN1 | LED Connector |
U3 | Autoboot EEPROM |
CN2 | 50pin SCSI Connector |
Contributions to this page by:
Andreas Kähler, Francisco Rabay Jr, Mario Misic, RiWa & Friends, Sebastien Ligez
Letzte Änderung des Artikels: 2009-01-29 10:32
Revision: 1.0
You cannot comment on this entry