- Home
- Show all categories
- Models & Clones
- A1000 Accelerators
- A1200 Accelerators
- A2000 Accelerators
- A3000 Accelerators
- A4000 Accelerators
- A500 Accelerators
- A600 Accelerators
- Bridgeboards & Emulator Cards
- CD32 Accelerators
- CDTV Accelerators
- Custom Chips
- Digtizers & Framegrabbers
- Flickerfixer & Scandoubler
- Floppy Controller
- Genlocks
- Graphics (non RTG) & Video Cards
- Graphics Cards (RTG)
- I/O Karten
- IDE Controller
- ISDN & Modem
- Keyboards & Adapters
- Kickstart Switchers
- MIDI Devices
- Misc ZORRO Cards
- Misc. Hardware
- Monitors
- Network Cards
- Processors
- RAM Expansions
- Scanner
- SCSI Controller
- Sound Cards
- Soundsampler
- Tape Drives & Backup
- Time Base Correctors
- Tower Kits
- Zorro Extenders & Busboards
- Mystery Corner
- Browse by Connection
- Sitemap
IDE Controller
3 State: Apollo 2000
Connection: Zorro II |
Apollo 2000
Apollo 2000 with HD attached
Hi Res Version, Apollo 2000 - 48K
Hi Res Version, Apollo 2000 with HD attached - 334K
Full length Zorro II card which provides you with both a SCSI and an IDE controller. The card is fully autobooting and has enough space to mount a hard drive directly onto the card. As well as an internal 50pin SCSI connector, an internal 40pin IDE connector the card also has an external 25pin SCSI connector and can transfer data at up to 3MB/sec (non DMA). It is also possible to add up to 8MB. The first 2MB may be added in the form of SIPPs or 1MB ZIP chips. The last 6MB must be added in form of 1MB ZIP chips. There are rumours that a version of this card supported 30pin SIMMs instead of SIPPs but this has not been confirmed. Both the SCSI/IDE and the RAM can be switched off for compatibility reasons using the DIP switches located near the backplate.
Contributions to this page by:
Andreas Schmidt, Christian Buker, Stefan Nilsson
Letzte Änderung des Artikels: 2009-01-25 21:27
Revision: 1.0
You cannot comment on this entry