- Home
- Show all categories
- Models & Clones
- A1000 Accelerators
- A1200 Accelerators
- A2000 Accelerators
- A3000 Accelerators
- A4000 Accelerators
- A500 Accelerators
- A600 Accelerators
- Bridgeboards & Emulator Cards
- CD32 Accelerators
- CDTV Accelerators
- Custom Chips
- Digtizers & Framegrabbers
- Flickerfixer & Scandoubler
- Floppy Controller
- Genlocks
- Graphics (non RTG) & Video Cards
- Graphics Cards (RTG)
- I/O Karten
- IDE Controller
- ISDN & Modem
- Keyboards & Adapters
- Kickstart Switchers
- MIDI Devices
- Misc ZORRO Cards
- Misc. Hardware
- Monitors
- Network Cards
- Processors
- RAM Expansions
- Scanner
- SCSI Controller
- Sound Cards
- Soundsampler
- Tape Drives & Backup
- Time Base Correctors
- Tower Kits
- Zorro Extenders & Busboards
- Mystery Corner
- Browse by Connection
- Sitemap
I/O Karten
Heldais: 8 Channel Serial Board
Zeus Electronic Developments: Spider |
Connection: Zorro II |
Pictures shows a Rev 1.0 card
Hi Res Version - 737K
The 8 Channel Serial Board, also known as the Spider is a half length Zorro II card which provides your Amiga with 8 x 25pin serial ports. The ports work at up to 57,600bps and support the MIDI rate of 31250. All 8 ports connect to the card via the 64pin ribbon which splits into serveral backplates. The card contains an onboard RISC coprocessor running at 11.1Mhz to help buffer the throughput when all serial ports are in use. Apparently the processor can be clocked up to 14.7Mhz to increase performance. The card requires at least WB 2.1 and uses spider.device
Contributions to this page by:
RiWa & Friends
Letzte Änderung des Artikels: 2009-01-25 21:06
Revision: 1.0
You cannot comment on this entry