- Home
- Show all categories
- Models & Clones
- A1000 Accelerators
- A1200 Accelerators
- A2000 Accelerators
- A3000 Accelerators
- A4000 Accelerators
- A500 Accelerators
- A600 Accelerators
- Bridgeboards & Emulator Cards
- CD32 Accelerators
- CDTV Accelerators
- Custom Chips
- Digtizers & Framegrabbers
- Flickerfixer & Scandoubler
- Floppy Controller
- Genlocks
- Graphics (non RTG) & Video Cards
- Graphics Cards (RTG)
- I/O Karten
- IDE Controller
- ISDN & Modem
- Keyboards & Adapters
- Kickstart Switchers
- MIDI Devices
- Misc ZORRO Cards
- Misc. Hardware
- Monitors
- Network Cards
- Processors
- RAM Expansions
- Scanner
- SCSI Controller
- Sound Cards
- Soundsampler
- Tape Drives & Backup
- Time Base Correctors
- Tower Kits
- Zorro Extenders & Busboards
- Mystery Corner
- Browse by Connection
- Sitemap
Kickstart Switchers
ID #3612
CMI (Creative Microsystems Inc): Kickstart Eliminator Expansion Kit
Connection: Other |
Socket spaces
Chips closeup
Chips
Soldered wire
Hi Res Version, Socket spaces - 605K
Hi Res Version, Chips closeup - 464K
Hi Res Version, Chips - 452K
Hi Res Version, Soldered wire - 230K
An expansion kit designed to give the A1000 real kickstart 1.2 chips in ROM form, so that the kickstart disk is no longer required.
The ROMs should be installed into U2N and U2P (two sets of 28 solder-holes) on the motherboard. In addition it is necessary to modify jumpers on the motherboardf, and replace a PAL (Programmable Array Logic) chip.
- Replace the 20pin PAL 16L8A-2CN chip located at U6J on the WCS daughterboard with the new chip supplied in the kit
- Desolder (using a desoldering vacuum pump) the holes at U2N and U2P.
- Modify jumpers W2 and W4.
Diagrams
Rev A motherboard
|
|---*
|
|
|
W1 *=* * W3 *=* *
|
W2 *=* * W4 * *=*
^ ^ ^ ^
| | | |
short cut cut short
Rev B motherboard
|
|---*
| |
| |
cut trace -> | <- bypass
| |
W1 *=* * W3 *=* * /
| /
W2 *=* * W4 *=* *
^ ^
| |
short cut
Contributions to this page by:
Takahasi Kasiko
Letzte Änderung des Artikels: 2009-01-26 14:21
Revision: 1.0
Average rating: 0 (0 Votes)
You cannot comment on this entry