ID #3246

Comp Serv: Comp Serv Scandoubler

Arxon: Arxon Scandoubler
Connection: Video Slot

Front of Arxon version
Front of Arxon version

Back of Arxon version
Back of Arxon version

Front of Comp Serv version
Front of Comp Serv version

Back of Comp Serv version
Back of Comp Serv version

Hi Res Version, Front of Arxon version - 875K
Hi Res Version, Back of Arxon version - 833K
Hi Res Version, Front of Comp Serv version - 690K
Hi Res Version, Back of Comp Serv version - 684K
More info on the scandoubler (German) - 154K

A basic scandoubler which takes a 15Khz PAL or NTSC screen and scandoubles it for use on an SVGA monitor via the use of a standard 15pin VGA connector. There are two sets of jumpers on the card. J2 enables the mode promoting of the Super72 800x600 screenmode, with the drawback that every second row is not displayed. It also requires a monitor which is capable of displaying a Horizontal frequency of approximately 48Khz. The other Jumper J1 is used for setting the correct display timing for both NTSC and PAL screens. For an A4000 the correct timing seems to be pins 2 + 3 being shorted on J1. Other Amiga models may require experimentation.

Contributions to this page by:
Pekka K Heiskanen, RiWa & Friends, Thomas Heinrich

Letzte Änderung des Artikels: 2009-01-25 17:42
Revision: 1.0

Drucken {writeSend2FriendMsgTag}
Rate this FAQ

Average rating: 0 (0 Votes)

completely useless 1 2 3 4 5 most valuable

Average rating: 0 (0 Votes)

You cannot comment on this entry