- Home
- Show all categories
- Models & Clones
- A1000 Accelerators
- A1200 Accelerators
- A2000 Accelerators
- A3000 Accelerators
- A4000 Accelerators
- A500 Accelerators
- A600 Accelerators
- Bridgeboards & Emulator Cards
- CD32 Accelerators
- CDTV Accelerators
- Custom Chips
- Digtizers & Framegrabbers
- Flickerfixer & Scandoubler
- Floppy Controller
- Genlocks
- Graphics (non RTG) & Video Cards
- Graphics Cards (RTG)
- I/O Karten
- IDE Controller
- ISDN & Modem
- Keyboards & Adapters
- Kickstart Switchers
- MIDI Devices
- Misc ZORRO Cards
- Misc. Hardware
- Monitors
- Network Cards
- Processors
- RAM Expansions
- Scanner
- SCSI Controller
- Sound Cards
- Soundsampler
- Tape Drives & Backup
- Time Base Correctors
- Tower Kits
- Zorro Extenders & Busboards
- Mystery Corner
- Browse by Connection
- Sitemap
I/O Karten
VMC: Hypercom 3+
Connection: Clock Port |
Hypercom 3+
Hypercom 3+ with additional serial cables
Hi Res Version, Hypercom 3+ - 573K
Hi Res Version, Hypercom 3+ with additional serial cables - 587K
Image of Hypercom 3+ with manual - 812K
Hypercom 3+ connection diagram - 999K
The Hypercom 3+ connects to the clock port of the A1200, or the expansion port found on the Buddha and Catweasel. It provides two high speed serial ports (460,000bps) and a high speed bi-directional parallel port (560,000bps). The card contains two 9pin serial ports built directly onto it, however if you wish to use 25pin serial ports or you need to extend them to position them easily inside your case then you can attach two serial connectors directly to the 10pin headers on the card. Once you have attached serial connectors to the headers you should NOT continue to use the 9pin built-in serial ports.
Contributions to this page by:
Francisco Rabay Jr, Harald Frank (VMC)
Letzte Änderung des Artikels: 2009-01-25 21:17
Revision: 1.0
You cannot comment on this entry