- Startseite
- Alle Kategorien anzeigen
- Modelle und Clones
- A1000 Turbokarten
- A1200 Turbokarten
- A2000 Turbokarten
- A3000 Turbokarten
- A4000 Turbokarten
- A500 Turbokarten
- A600 Turbokarten
- Bridgeboards & Emulatorkarten
- CD32 Turbokarten
- CDTV Turbokarten
- Custom Chips
- Digitiser & Framegrabber
- Flickerfixer & Scandoubler
- Floppy Controller
- Genlocks
- Grafik (non RTG) & Videokarten
- Grafikkarten (RTG)
- I/O Karten
- IDE Controller
- ISDN & Modem
- Tastaturen & Adapter
- Kickstart Umschalter
- MIDI Geraete
- versch. ZORRO Karten
- verschiedene Hardware
- Monitore
- Netzwerk Karten
- Prozessoren
- RAM Erweiterungen
- Scanner
- SCSI Controller
- Sound Karten
- Soundsampler
- Bandlaufwerke & Backup
- Time Base Correctors
- Tower Kits
- Zorro Erweiterungen & Busboards
- Mystery Corner
- Suche über Anschluss
- Sitemap
ISDN & Modem
Alfa Data: Alfapower 500
BSC: Alfapower 500 |
Connection: Seitlicher Expansion Slot |
Back of Alfapower 500
Front of Alfapower 500
Image of Alfapower 500 motherboard inside case with 2.5" HD, ZIP Version - 306K
Image of Alfapower 500 motherboard inside case, ZIP version - 504K
Image of Alfapower 500 motherboard, ZIP version - 491K
Hi Res Version, Back of Alfapower 500 - 36K
Hi Res Version, Front of Alfapower 500 - 67K
Image of Alfapower 500 motherboard, SIMM version - 67K
Closeup of Alfapower 500 with HD, SIMM version - 65K
Closeup of Alfapower 500 SIMM slots - 71K
An IDE controller which connects to the side expansion slot of the A500/+ which requires at least Kickstart 1.3 and 512k of RAM. The unit contains both a 3.5" header and a 2.5" header for up to two IDE drives. The unit also supports additional memory up to a maximum of 8MB in the form of ZIP Chips, or 72pin SIMMs depending on the version you have. Supported memory configurations are 2/4/6/8MB using up to 16 1024x4bit DRAM ZIPs which must be faster than 80ns. The front of the unit contains two buttons, the left button disables or enables the RAM whilst the right button disables or enables the IDE controller. The rear of the unit has a power connector for an optional external power supply, as well as access to the 3.5" IDE header for attaching an externally mounted hard drive as there is only sufficient room inside the case for mounting one drive. Jumper descriptions are printed on the motherboard.
Contributions to this page by:
Andy Johnson, Marc Bradshaw, Sascha Coltrane
Letzte Änderung des Artikels: 2009-01-25 21:29
Revision: 1.0
Kommentieren nicht möglich